Skip to content
pCon.configurator onlineDocumentation
Esc
↑↓navigate↵open⌘Jpreview
On this page

Unit Format Settings

Synopsis

egr.eai.gf.UnitFormatter.LengthUnit=<length-unit>
egr.eai.gf.UnitFormatter.LengthRepresentation=<unit-repr>
egr.eai.gf.UnitFormatter.LengthPrecision=<integer>
egr.eai.gf.UnitFormatter.LengthGrouping=<boolean>
egr.eai.gf.UnitFormatter.LengthUnitDisplayed=<boolean>
egr.eai.gf.UnitFormatter.LengthUpperCase=<boolean>
egr.eai.gf.UnitFormatter.AngleUnit=<angle-unit>
egr.eai.gf.UnitFormatter.AnglePrecision=<integer>
egr.eai.gf.UnitFormatter.AngleZeroDirection=<floating-point>
egr.eai.gf.UnitFormatter.MaxAngle=<floating-point>
egr.eai.gf.UnitFormatter.AngleUnitDisplayed=<boolean>
egr.eai.gf.UnitFormatter.AngleMathPositive=<boolean>
egr.eai.gf.UnitFormatter.AreaUnit=<area-unit>
egr.eai.gf.UnitFormatter.AreaRepresentation=<unit-repr>
egr.eai.gf.UnitFormatter.AreaPrecision=<integer>
egr.eai.gf.UnitFormatter.AreaGrouping=<boolean>
egr.eai.gf.UnitFormatter.AreaUnitDisplayed=<boolean>
egr.eai.gf.UnitFormatter.AreaUpperCase=<boolean>
<length-unit>: mm|cm|dm|m|in|ft|in_dq|ft_sq|architectural|yd
<angle-unit>: degrees|radians
<area-unit>: mm2|cm2|dm2|m2|sq_in|sq_ft|sq_yd
<unit-repr>: scientific|fixed|auto|fraction

in_dq stands for inch represented with double quotes. ft_sq means feet represented as single quote and architectural is the combination of ft_sq and in_dq with - as delimiter.

The length representation scientific stands for floating-point numbers. fixed represents fixed-point numbers. auto shows the numbers depending on the value either as floating-point number or fixed-point number. fraction represents the number as fraction.

LengthUnitDisplayed defines whether units should be displayed. LengthUpperCase defines whether the exponent should be represented with capital or small E (only in case of scientific or auto with corresponding value).

AngleZeroDirection defines the direction of the 0-degree-angle in radian measure. It is subtracted from an absolute angle before formating. MaxAngle defines the maximum angle in radian measure. After converting the angle which should be displayed into ]-2pi,+2pi[ 2pi is subtracted in case the angle is bigger as the maximum angle or 2pi is added in case the angle is negative and after adding 2pi smaller or equal the maximum angle.